EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT

$25.00$45.00

EHS Protection Gear products for EHS people are special products that can make EHS people life’s a bit better when handling EHS. These products are mainly for EHS people. Most of them should be used after you have reduced your exposure to EMF ,after using an EMF meter, after you have stopped using RF emitting products and used RF Protection on the house. Please see more info in our disclaimer page.

EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT for EHS people is made out of the S190 RF Blocking fabric. It is made to block HIGH and MID FREQUENCY EMF emitted from Wired routers, network splitters, USB hubs, and other PC/Electronic equipment.
SKU: N/A Category:

Description

Please read before making an order!

This product is for EHS people that stopped using wireless devices

If you are not an EHS(Electromagnetic Hypersensitive) person, most likely that you will not feel this EMF emission from wired PC and electronic equipment.  In addition, if you use wireless phones, mobiles, and laptops than the RF emission from these devices is 1000000 times or more, stronger than the emission from the wired equipment.  So there is no logic in using the EMF protection for equipment if you are not an EHS person or if you still use wireless devices.
For more info that explains the issue press here…

About the EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT

The EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT for EHS people is made out of the S190 RF Blocking fabric.
It is meant to block HIGH and MID FREQUENCY EMF emitted from Wired routers, network splitters, USB hubs, and other PC/Electronic equipment.
This EMF is very low and almost unmeasurable, but some of the most sensitive EHS people might feel it.
  • The equipment should be inserted into the protection.
  • The protection can be grounded using the clips or the open side of it.
  • Fabric: S190 RF blocking fabric
  • Made In Israel
  • Sent from Israel

 

Video Demonstration

Video review of the EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT for EHS people – https://youtu.be/JlVmz-KShEU

Installation

  1. Insert your equipment into the protective case
  2. Connect the wires via the open side of the case
  3. Make sure the equipment inside the protection does not heat up
  4. Optional – Ground it to the real ground or floor (not to electric ground)

Additional information

Weight 0.1 kg
Dimensions N/A
NCEP190

15X15cm, 25X25cm, 49X34cm

Reviews

There are no reviews yet.

Be the first to review “EMF PROTECTION CASE FOR PC\ELECTRONIC EQUIPMENT”

Your email address will not be published. Required fields are marked *